HackFFM-Duino Chime: Unterschied zwischen den Versionen
Aus Hackerspace Ffm
DCEM (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „LeandraChristine needed a small solution for a project. Since I was designing lots of PCB’s anyway I decided to also realize this …“) |
DCEM (Diskussion | Beiträge) |
||
Zeile 1: | Zeile 1: | ||
+ | |||
+ | == Motivation == | ||
[[Benutzer:LeandraChristine|LeandraChristine]] needed a small solution for a project. Since I was designing lots of PCB’s anyway I decided to also realize this one. | [[Benutzer:LeandraChristine|LeandraChristine]] needed a small solution for a project. Since I was designing lots of PCB’s anyway I decided to also realize this one. | ||
Zeile 12: | Zeile 14: | ||
The controller itself is running on 3.3V (because of the SD-Card). The supply voltage is 5V. | The controller itself is running on 3.3V (because of the SD-Card). The supply voltage is 5V. | ||
+ | |||
+ | == License == |
Version vom 5. September 2014, 18:54 Uhr
Motivation
LeandraChristine needed a small solution for a project. Since I was designing lots of PCB’s anyway I decided to also realize this one.
Its es ment to be used with the SimpleSDAudio-library from Tut, who helped quite a lot with the circuit design in this project.
The board is carrying: Atmega328 MAX9098306 3.7W stereo Class D amplifier SN74LVC2G14 dual Schmitt-Trigger with its own low noise power supply microSD-Card Slot 74LVC1G53DP Analog Switch, to set the gain of the Class D amplifier (3 levels)
The controller itself is running on 3.3V (because of the SD-Card). The supply voltage is 5V.