OpenSCAD small projects: Unterschied zwischen den Versionen
Aus Hackerspace Ffm
Axl (Diskussion | Beiträge) K (+ Fan protective grille) |
Axl (Diskussion | Beiträge) K (→Fan protective grille) |
||
Zeile 12: | Zeile 12: | ||
* Running at 5 Volts keeps it at a lower noise level. | * Running at 5 Volts keeps it at a lower noise level. | ||
* To avoid (further) hurts, the fan needed a grille. | * To avoid (further) hurts, the fan needed a grille. | ||
− | * OpenSCAD --> STL export --> yag-freak's Prusa Mendel | + | * OpenSCAD Script [[Datei:Fan-Protector 005.scad|Fan-Protector 005.scad]] |
+ | ** --> STL export | ||
+ | *** --> 3D print on yag-freak's Prusa Mendel - thank you! | ||
<br/> | <br/> | ||
Zeile 22: | Zeile 24: | ||
Datei:Foto1793.jpg|Safety first! | Datei:Foto1793.jpg|Safety first! | ||
</gallery> | </gallery> | ||
− | |||
== OpenSCAD Tipps, Tutorials etc. == | == OpenSCAD Tipps, Tutorials etc. == |
Version vom 1. Dezember 2011, 08:12 Uhr
A collection of smaller projects using OpenSCAD:
Fan protective grille
- The Hackerspace main network switch was quiet noisy.
- Original 40 mm internal fan (5 Volt) was replaced by an external 70 mm & 12 Volt model.
- Running at 5 Volts keeps it at a lower noise level.
- To avoid (further) hurts, the fan needed a grille.
- OpenSCAD Script Datei:Fan-Protector 005.scad
- --> STL export
- --> 3D print on yag-freak's Prusa Mendel - thank you!
- --> STL export