HackFFM-Duino Chime: Unterschied zwischen den Versionen
DCEM (Diskussion | Beiträge) |
DCEM (Diskussion | Beiträge) |
||
| Zeile 6: | Zeile 6: | ||
Since I was designing lots of PCB’s anyway I decided to also realize this one. | Since I was designing lots of PCB’s anyway I decided to also realize this one. | ||
Another requirement was fast responsiveness. The [[SimpleSDAudio]]-library from [[Benutzer:Tut|Tut]] provides just that. [[Benutzer:Tut|Tut]] helped quite a lot with the circuit design in this project. | Another requirement was fast responsiveness. The [[SimpleSDAudio]]-library from [[Benutzer:Tut|Tut]] provides just that. [[Benutzer:Tut|Tut]] helped quite a lot with the circuit design in this project. | ||
| − | |||
| − | |||
== Features == | == Features == | ||
| Zeile 25: | Zeile 23: | ||
8 Pins are accessible including i²C PINS | 8 Pins are accessible including i²C PINS | ||
| + | |||
| + | == Design Files == | ||
== License == | == License == | ||
Licensing CC v4.0 Share-Alike (http://creativecommons.org/licenses/by-sa/4.0/) | Licensing CC v4.0 Share-Alike (http://creativecommons.org/licenses/by-sa/4.0/) | ||
| + | |||
| + | I started out with the open log design. Although there is not much left of it, it was some help. | ||
| + | |||
| + | I also used libraries from sparkfun and adafruit. | ||
[[Kategorie:Projekte]] | [[Kategorie:Projekte]] | ||
Version vom 5. September 2014, 21:00 Uhr
by: DCEM
Inhaltsverzeichnis
Motivation
LeandraChristine needed a small solution for sound in a project. Since I was designing lots of PCB’s anyway I decided to also realize this one. Another requirement was fast responsiveness. The SimpleSDAudio-library from Tut provides just that. Tut helped quite a lot with the circuit design in this project.
Features
The board is carrying:
- Atmega328
- MAX9098306 3.7W stereo Class D amplifier
- SN74LVC2G14 dual Schmitt-Trigger with its own low noise power supply
- microSD-Card Slot
- 74LVC1G53DP Analog Switch, to set the gain of the Class D amplifier (3 levels)
The controller itself is running on 3.3V (because of the SD-Card). The supply voltage is 5V.
Choose between 8bit Stereo or 16bit mono Sound.
Board size: 15 x 30mm(0.6 x 1.2 inches)
8 Pins are accessible including i²C PINS
Design Files
License
Licensing CC v4.0 Share-Alike (http://creativecommons.org/licenses/by-sa/4.0/)
I started out with the open log design. Although there is not much left of it, it was some help.
I also used libraries from sparkfun and adafruit.
